Electric heating and hot water.
Storage heaters, panel heaters, underfloor heating, immersion heaters and electric showers. Installed on the right circuits, with the right controls.
Warmth without the gas.
Plenty of homes and flats run entirely on electricity, and more people are choosing electric heating in extensions, loft conversions and garden rooms. Modern heaters are far more controllable than the old storage heaters many people remember.
Heating and hot water draw a lot of current, so the circuits behind them matter. We make sure every heater, shower and immersion has a correctly sized cable and the right protection, and that your supply can cope with the extra load.
Common heating and hot water jobs
- Old storage heaters that are hard to control
- Cold extensions, loft rooms or garden rooms
- Underfloor heating under new tiles or flooring
- An immersion heater that has failed or needs a timer
- A new or more powerful electric shower
- Rooms with no heating at all
What's included.
Storage heaters
Modern, controllable storage heaters wired for off peak tariffs.
Panel heaters
Wall mounted panel heaters with thermostats and timers.
Underfloor heating
Electric mats and cables under tiles and floors, with smart thermostats.
Immersion heaters
Elements, timers and controls replaced and wired correctly.
Electric showers
Dedicated circuits sized for the shower rating, with suitable protection.
Tested and certified
Certificates for new circuits, and building control notified where required.
Getting the circuit right.
An electric shower or a set of storage heaters can draw more current than anything else in the house. Upgrading to a bigger shower often means a new, larger cable back to the consumer unit, not just swapping the unit on the wall. We check the existing circuit and your supply before quoting.
For underfloor heating, we work with your floor layer or tiler so the mat goes down at the right stage, and test it before and after it is covered. Controls are set up with you, so you know how to get the most from your tariff.
Accredited and approved.
NICEIC Approved Contractor (registration no. 609893000), SafeContractor approved, and ECS-carded electricians on every job.
How it works.
Get in touch
Tell us what you need by phone, email or the form. A few details is plenty.
Survey and quote
We see the job before we price it, then put a clear quote in writing.
Tidy installation
Work planned around your home or site, with everything left clean.
Test and certify
Every circuit and cable tested, with the certificates handed over.
Electric heating and hot water near you.
Based in Dartford, we carry out electric heating and hot water across Kent, London and south Essex.
Questions about electric heating.
Can I fit a more powerful electric shower on my existing cable?
Sometimes, but often not. A higher rated shower usually needs a larger cable and suitable protection. We check the circuit before recommending a shower.
Are modern storage heaters better than old ones?
Yes. Newer models hold their heat better and have electronic controls, so you get warmth when you want it rather than all morning.
Is electric underfloor heating expensive to run?
It works best in well insulated rooms such as bathrooms, kitchens and extensions. A good thermostat and timer make a big difference to running costs.
Do you install gas boilers?
No. We work on electric heating and hot water only. For gas appliances you need a Gas Safe registered engineer.
Can you fit a timer to my immersion heater?
Yes. A timer or smart controller lets you heat water when you need it, and on cheaper tariffs where you have one.
Related services.
Consumer unit replacement
Replace an old fuse box with a modern consumer unit, with the RCD and surge protection current regulations expect. Usually done in a day.
House rewiring
Full and partial rewires for older homes, extensions and renovations across Kent, London and south Essex. Clear quotes, tidy work and full certification.
Smart home and lighting control
Smart switches, lighting scenes, heating controls and the network behind them. Planned and wired so your smart home works every day, not just on day one.
Tell us about the job.
A few details is plenty. We will come back to you to arrange a visit and a written quote.